Call 7 days a week:  855-306-6466
Menu

I often hear concerns about using Sea-Cycles & Water Bikes in salt water.

 Our units are made from the highest grade materials to resist salt water corrosion.

 

HULLS & STRUTS:  

Polyethylene with UVA & UVB color protection; unsinkable computer designed hulls

 

FASTENERS & HARDWARE:  

High Grade Stainless Steel & Brass Fasteners

 

MAIN FRAME RAILS:  

T-6 marine aluminum components with a two step anodizing for best paint wear & corrosion resistance

 

DRIVE UNIT: 

Cross linked polymer housing withstands impacts & is corrosion free.  Oil filled sealed sump lubricates all moving & friction parts with every pedal revolution preventing corrosion & wear. Sealed housing is impervious to salt water intrusion.

 

We recommend:

Rinsing your unit with fresh water after use just as you would any other boat & motor.

Remove drive units when not in use & store upright in a dry location.  

After each use, inspect the propeller & drive shaft for foreign objects such as seaweed. Foreign objects may damage the seal on the propeller shaft. Check or replace it annually.

Want to keep your Sea-Cycle or Water Bike looking like new? Wipe it down with WD40! They have a new water resistant line: WD-40® SPECIALIST™ WATER RESISTANT SILICONE LUBRICANT safely lubricates, waterproofs and protects metal and non-metal surfaces, including rubber, plastic and vinyl. It dries fast and leaves a clear, non-staining film that doesn’t stick or make a mess, so it won’t attract dirt. 

 

A little maintenance will guarantee many years of carefree use of your

Sea-Cycle or Water-Bike!

  

Subject to change without notice.

 All content including photos are copyrighted & cannot be used for any reason without expressed written permission of the owner.

Call us Toll Free: 855-306-6466